This example is not factual - it is purely illustrative of the infobox.
|
|||
Type | Analogue video connector | ||
---|---|---|---|
Production history | |||
Designer | Some guy | ||
Designed | Early 1990s | ||
Manufacturer | Initially Toshiba | ||
Produced | Early 1990s to 2005 | ||
Superseded | RF connector | ||
Superseded by | DVI connector (2005) | ||
General specifications | |||
Length | 36 mm (typical) | ||
Width | 25 mm | ||
Height | 6.5 mm | ||
Hot pluggable | Yes | ||
External | External | ||
Audio signal | None | ||
Video signal | Analogue 480i, 480p, 720p, 1080i | ||
Cable | 14 core shielded (25 m max) | ||
Passband | 0-20 GHz | ||
Pins | 14 (6 video, 3 reserved, 2 detect, 3 data) | ||
Connector | DB-25 | ||
Electrical | |||
Signal | 220 volts AC 50 Hz typically | ||
Earth | Dedicate pin | ||
Max. voltage | 450 volts peak | ||
Max. current | 20 amps at 220 volts, 5 amps at 400 volts | ||
Data | |||
Data signal | Resolution and Aspect ratio only | ||
Width | 2 bits | ||
Bitrate | 120 bit/s | ||
Max. devices | 1 | ||
Protocol | Serial | ||
Pin out | |||
A male connector seen from the front. | |||
Pin | Spec name | Example col title | |
Pin 1 | Y | luminance (0.7 V, 75 Ω) | |
Pin 2 | Y GND | Y ground | |
Pin 3 | Pb | 0.35 V, 75 Ω | |
Pin 4 | Pb GND | ||
Pin 5 | Pr | 0.35 V, 75 Ω | |
Pin 6 | Pr GND | ||
Pin 7 | Reserve link 1 | ||
Pin 8 | Data line 1 | 0 V = 525 lines 2.2 V = 750 lines 5 V = 1125 lines |
|
Pin 9 | Data line 2 | 0 V = 59.94i / 60i 5 V = 59.94p / 60p |
|
Pin 10 | Reserve link 2 | ||
Pin 11 | Data line 3 | 0 V = 4:3 2.2 V = 4:3 letterbox 5 V = 16:9 |
|
Pin 12 | Plug insert detect ground | ||
Pin 13 | Reserve link 3 | ||
Pin 14 | Plug insert detect | output 10 kΩ, input > 100 kΩ | |
C1 | BLUE | Analog Blue Video | |
C2 | GREEN | Analog Green Video | |
C3 | HA_SYNC | Analog Horizontal Sync | |
C4 | RED | Analog Red Video | |
C5 | RETURN | Analog RGB Return and DDC Return | |
C6 | AR_PRE | Acid reflux preventer | |
C7 | AR_ENC | Acid reflux encourager | |
C8 | CHRO | Churro presence detect | |
These are some notes about the pinout of this connector. The pins are razor sharp. |
Connector Infobox is an infobox for electrical and (audio/video) signal connectors of all kinds.
Notes
The template supports three images:
- image, logo, pinout_image
Image and logo share a 300 pixel wide area - so if both are used then the width of the image should be set to 150 pixels, that is, [[Image:example.jpg|150px]]. If only image and pinout are used, then the size of both should be 300 pixels.
Parameters and usage
{{Infobox connector | name = | type = | image = | logo = | caption = | designer = | design_date = | manufacturer = | production_date = | superseded = | superseded_by = | superseded_by_date = | weight = | length = | diameter = | width = | height = | hotplug = | daisy_chain = | external = | electrical = | earth = | maximum_voltage = | maximum_current = | audio_signal = | video_signal = | data_signal = | data_bit_width = | data_bandwidth = | data_devices = | data_style = | cable = | high_freq = | physical_connector = | num_pins = | pinout_col1_name = | pinout_col2_name = | pinout_image = | pinout_caption = | pinout_image2 = | pinout_caption2 = | pin1 = | pin1_name = | pin2 = | pin2_name = | pin3 = | pin3_name = | pin4 = | pin4_name = | pin5 = | pin5_name = | pin6 = | pin6_name = | pin7 = | pin7_name = | pin8 = | pin8_name = | pin9 = | pin9_name = | pin10 = | pin10_name = | pin11 = | pin11_name = | pin12 = | pin12_name = | pin13 = | pin13_name = | pin14 = | pin14_name = | pin15 = | pin15_name = | pin16 = | pin16_name = | pin17 = | pin17_name = | pin18 = | pin18_name = | pin19 = | pin19_name = | pin20 = | pin20_name = | pin21 = | pin21_name = | pin22 = | pin22_name = | pin23 = | pin23_name = | pin24 = | pin24_name = | pin25 = | pin25_name = | pin26 = | pin26_name = | pin27 = | pin27_name = | pin28 = | pin28_name = | pin29 = | pin29_name = | pin30 = | pin30_name = | pin31 = | pin31_name = | pin_custom1_name = | pin_name_custom1 = | pin_custom1 = | pin_custom2_name = | pin_name_custom2 = | pin_custom2 = | pin_custom3_name = | pin_name_custom3 = | pin_custom3 = | pin_custom4_name = | pin_name_custom4 = | pin_custom4 = | pin_custom5_name = | pin_name_custom5 = | pin_custom5 = | pin_custom6_name = | pin_name_custom6 = | pin_custom6 = | pin_custom7_name = | pin_name_custom7 = | pin_custom7 = | pin_custom8_name = | pin_name_custom8 = | pin_custom8 = | pinout_notes = }}